tools and

farm tools

and slide rules

and office

American Artifacts
Site Contentsonline articles online catalog

Stanley No. 210 Mitre Cutter

The two fixed blades cut left or right 45 degree miters. A metal plate on the wood base reads "The Stanley Works, New Britain, CONN, USA". Cast on the back of the handle is"MADE IN USA, No. 210". While Stanley made these machines around the 1930's, this is a much older design, patented in 1858, by Stephen Hall, of Williamsport, PA. Hall's mitre cutter is advertised in the 1867 catalog of A.J. Wilkinson.

The blades are sharp and the iron is fine. The wood base shows much use and has the usual paint drips. Good working order.

the knives set at 90 degrees

the reverse side

rear side of the handle marked "Made in USA, No. 210"

Price: sold.
Items reserved by email will be held 10 days and shipped upon receipt of your check. Please wait to mail your check or send Paypal payment until you receive email confirmation of your reservation.

Contact: Richard Van Vleck - Email:
Send payment to: American Artifacts, PO Box 412, Taneytown, MD 21787

© 2006, American Artifacts, Taneytown, Maryland.