Champion No. 108 Post Drill
The No. 108 is a small drill with grooved flywheel for use with a round belt drive, if desired. Center to post is 3 3/4" (7 1/2" dia circle). 6" diameter flywheel, 1/2" chuck, 26" backboard. Non-adjustable self feed.
The drill runs smoothly, however, the self feed skips due to wear of the teeth on the hand wheel. Hand filing to reface the teeth would cure this, but there are a lot of teeth. Also, the flywheel shaft is slightly bent, causing the pulley to not run true. This doesn't affect the shaft bearings or balance, since the bend is right at the flywheel. It was likely dropped at some time.
closeup of flywheel side
crank side
front view
Price: sold plus UPS
This item can be safely stored until your next trip to Maryland
Items reserved by email will be held 10 days and shipped upon receipt of your check. Please wait to mail your check until you receive email confirmation of your reservation.
Contact: Richard Van Vleck - Email: richard@americanartifacts.com
© 2006, American Artifacts, Taneytown, Maryland.
| 
